←back to thread

293 points cjr | 2 comments | | HN request time: 0.593s | source
Show context
decimalenough ◴[] No.44536914[source]
> The aircraft achieved the maximum recorded airspeed of 180 Knots IAS at about 08:08:42 UTC and immediately thereafter, the Engine 1 and Engine 2 fuel cutoff switches transitioned from RUN to CUTOFF position one after another with a time gap of 01 sec. The Engine N1 and N2 began to decrease from their take-off values as the fuel supply to the engines was cut off.

So the fuel supply was cut off intentionally. The switches in question are also built so they cannot be triggered accidentally, they need to be unlocked first by pulling them out.

> In the cockpit voice recording, one of the pilots is heard asking the other why did he cutoff. The other pilot responded that he did not do so.

And both pilots deny doing it.

It's difficult to conclude anything other than murder-suicide.

replies(25): >>44536947 #>>44536950 #>>44536951 #>>44536962 #>>44536979 #>>44537027 #>>44537520 #>>44537554 #>>44538264 #>>44538281 #>>44538337 #>>44538692 #>>44538779 #>>44538814 #>>44538840 #>>44539178 #>>44539475 #>>44539507 #>>44539508 #>>44539530 #>>44539532 #>>44539749 #>>44539950 #>>44540178 #>>44541039 #
alephnerd ◴[] No.44536951[source]
> It's difficult to conclude anything other than murder-suicide.

Is it possible it could have been an accident or a mistake by one of the pilots? How intention-proofed are engine cutoffs?

replies(2): >>44537006 #>>44537365 #
xenadu02 ◴[] No.44537365[source]
It could be defective switch springs, fatigue-induced muscle memory error, or something else. The pilot who did it saying he did not may not have realized what he did. It's pretty common under high workload when you flip the wrong switch or move a control the wrong way to think that you did what you intended to do, not what you actually did.

That said Boeing could take a page out of the Garmin GI275. When power is removed it pops up a "60s to shutdown dialog" that you can cancel. Even if you accidentally press SHUTDOWN it only switches to a 10s countdown with a "CANCEL" button.

They could insert a delay if weight on wheels is off. First engine can shutdown when commanded but second engine goes on 60s delay with EICAS warning countdown. Or just always insert a delay unless the fire handle is pulled.

Still... that has its own set of risks and failure modes to consider.

replies(3): >>44537836 #>>44538111 #>>44538204 #
aerospace83 ◴[] No.44538111[source]
Armchair safety/human factors engineering, gotta love HN.
replies(2): >>44538342 #>>44539173 #
zahlman ◴[] No.44538342[source]
This is a place that puts "Hacker" in the name despite the stigma in the mainstream. Given the intended meaning of the term, I would naturally expect this to be a place where people can speculate and reason from first principles, on the information available to them, in search of some kind of insight, without being shamed for it.

You don't have to like that culture and you also don't have to participate in it. Making a throwaway account to complain about it is not eusocial behaviour, however. If you know something to be wrong with someone else's reasoning, the expected response is to highlight the flaw.

replies(3): >>44538912 #>>44538954 #>>44538958 #
1. macintux ◴[] No.44538912[source]
For me it's mainly about intent/unearned confidence.

If someone is speculating about how such a problem might be solved while not trying to conceal their lack of direct experience, I'm fine with it, but not everyone is.

If someone is accusing the designers of being idiots, with the fix "obvious" because reasons, well, yeah, that's unhelpful.

replies(1): >>44539691 #
2. michaelmrose ◴[] No.44539691[source]
I don't think most think they know better but it's frankly fun to speculate and this is a casual space rather than the serious bodies tasked with actually chewing over this problem in earnest.