←back to thread

Design for 3D-Printing

(blog.rahix.de)
837 points q3k | 1 comments | 04 May 25 17:38 UTC | HN request time: 0s | source
Show context
WillAdams ◴[04 May 25 20:03 UTC] No.43889141[source]▶
One technique which bears mentioning is printing in 100% infill using a filament which will allow re-heating/cooling and then putting it in a tray of powder salt (very finely ground table salt) and then backing and cooling it.
replies(2): >>43889178 #>>43892057 #
1. DannyBee ◴[05 May 25 05:04 UTC] No.43892057[source]▶
Sure, but at that point, you'd almost certainly be better off using resin.