←back to thread

254 points Michelangelo11 | 2 comments | | HN request time: 0.498s | source
1. graycat ◴[] No.42058343[source]
Welding Example:

Brother and I bought and old Chevy. Front end parts so badly worn that could turn steering wheel about 20 degrees before the wheels moved!

Used bumper jacks to raise the front end and rest it on concrete blocks. Took out everything from the steering wheel to the front wheel. The springs were dangerous -- kaBOOM!

Took the worn parts to a Chevy parts department -- they enjoyed helping a teenager do it yourself, first time.

Installed the new parts: Had no spring compressor so used two bumper jacks; had them supporting the car while also using the jacks on the lower A-frames to compress the springs. kaBOOM! as one of the jacks slipped, the spring expanded, the lower A-frame rotated ~180 degrees and hit near the center of the frame (but not me!).

Drove the car to our Buick dealer (family car was a Buick) to have the front end aligned. Mechanic was surprised and pleased to see the work done -- all nice clean parts correctly installed! But he said he couldn't do the alignment because he needed a bending bar for the king pin (vertical heavy iron bar connecting the outer ends of the lower and upper A-frames) so sent me to the shop of a friend. The friend said "Bet you got these nuts too tight ... no you didn't. How'd you know to do that?" Had read a maintenance manual at the city library. He said "We get those manuals ..."!

Shocks were part of the upper A-frame pivots and poor. At a parts shop, got two piston shocks that looked about right, were officially for some Mercury car, and drove to a muffler shop for the needed welding. The shop was pleased to help a do it yourself teenager and with a challenge well outside their usual welding. So, with some fabrication and welding, they got each shock attached to the frame and the front side of the lower A-frame. Worked great for years!

Lesson connected with the OP: People can like helping a teenager do it yourself, alone, a first time, with too little or nothing in information and tools and facing some danger. The muffler shop liked the challenge of doing the one-off, first-time, innovative fabrication and welding! Such a teenager can get a good welcome and respect.

replies(1): >>42065633 #
2. mmooss ◴[] No.42065633[source]
The welcome they get may depend on their race and gender.